HOW TO FIX YOUR AUDYA IF NOTHING WORKS

[♔Chello]

DO NOT TRUST WHAT KETRON USA SAYS

As previously mentioned, I managed to fix my Ketron Audya by inserting cloned files from one I had previously on a new disk.
Everything worked without bugs, and almost all styles worked 100%; only some audio styles were out of sync.
Also, I got the error message "Checksum error" when I used the software Compiler.

I found the following "fix" written by AJ (Mr. Ajamsonic) at Ketron USA that should fix this:

* Turn on your AUDYA.
* When it boots, press DISK to display the HD contents.
* Create a TEMP folder where you will be copying files into (shown below).
* After creating the TEMP folder, Scroll down to the file "9708f1av00.sam and press ENTER to load it. This prepares AUDYA to load the relative FLASH file next.
* When done, go to the SYSTEM folder and press enter (acknowledge warning by pressing ENTER again).
* Select the FACTORY folder and press ENTER.
* Select the SOUND folder and press ENTER.
* Go to the file "Audb0600.PCM" and highlight. [This is the file associated with the KetA05 chip]. Press DISK MENU and press ENTER to select this file (blue dot next to it).
* Press COPY (F1) to copy this file.
* Go back to temp folder created above and press EXECUTE to paste this file in there.
* Get out of DISK mode.
* Go back into disk and go into the TEMP folder to highlight and press ENTER on this file "Audb0600.PCM" to load it.
* When done, restart AUDYA.


I shouldn't have tried this, because the procedure results in a complete crash of all sounds.
The only thing I can do is clone everything again...

Damn take AJ at Ketron USA and his incompetence..!